Half Section; Face View; View - Siemens SINUMERIK 840D sl Turning Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl Turning:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Simulating machining
7.5 Different views of the workpiece
7.5.2
Half section
Displaying a half cut view
Changing the display
You can increase or decrease the size of the simulation graphic and move it, as well as change
the segment.
7.5.3
Face view
Displaying a face view
Changing the display
You can increase or decrease the size of the simulation graphic and move it, as well as change
the segment.
7.5.4
3D view
Displaying a 3D view
246
1.
Simultaneous recording or simulation is started.
2.
Press the "Further views" and "Half cut view" softkeys.
The half cut view shows the workpiece cut in the Z-X plane.
1.
Simultaneous recording or simulation is started.
2.
Press the "Further views" and "Face view" softkeys.
The side view shows the workpiece in the X-Y plane.
1.
Simultaneous recording or simulation is started.
2.
Press the "3D view" softkey.
Operating Manual, 06/2019, A5E44903486B AB
Turning
Advertisement
Table of Contents
