Siemens SINUMERIK 840D sl Turning Operating Manual page 200
Hide thumbs
Also See for SINUMERIK 840D sl Turning:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Machining the workpiece
6.11 Working with DXF files
Cleaning a file
Specifying a reference point
Specify clearance(s) (position pattern "Row"/"Arbitrary positions" and "Circle"/"Pitch circle"
Specify clearance with second clearance (for position pattern "Frame", "Grid")
Size (position pattern "Row", "Frame", "Grid")
Circle direction (circle and pitch circle)
Resetting actions
Transfer drilling positions to the cycle and the program
200
3.
Press the "OK" softkey.
The CAD drawing opens and the cursor takes the form of a cross.
4.
Prior to selecting the drilling positions, you can select a layer and clean
the file.
5.
If required, specify a zero point.
6.
Press the "Select element" softkey repeatedly to navigate through the
orange selection symbol to the desired drilling position.
7.
Press the "Accept element" softkey to transfer the position.
Repeat steps 6 and 7 to specify other drilling positions for "Arbitrary po‐
sitions".
8.
Once the reference point has been specified, press the "Select element"
softkey repeatedly to navigate to the desired drilling position in order to
specify the clearance.
9.
Press the "Accept element" softkey.
A rectangular cross-hair appears.
10.
Press the "Select element" repeatedly to navigate to the desired drilling
position on the displayed line.
To determine the second clearance, drilling positions must be located on
the line.
11.
Press the "Accept element" softkey.
A frame or grid is displayed.
12.
Once the reference point and clearances have been specified, press the
"Select element" softkey repeatedly.
All expansions of the frame or the grid are displayed.
13.
Press the "Accept element" softkey to confirm the selected frame or grid.
If all elements for the position row or position frame and position grid are
valid, the drilling positions are displayed with blue points.
Once the reference point and clearance have been specified, press the
"Select element" softkey repeatedly.
The circle is shown in the possible orientations.
Press the "Select element" softkey to confirm the selected circle or pitch
circle.
If all elements of the circle or pitch circle are valid, the drilling positions are
displayed with blue points.
Undo can be used to reset the last actions.
Operating Manual, 06/2019, A5E44903486B AB
Turning
Advertisement
Table of Contents
