Plunge-Cutting Rest (Cycle952) - Siemens SINUMERIK 840D sl Turning Operating Manual

Parameter Description
ZD - (only for ∇ machining)
- (only for blank description, cylinder and allowance)
● For blank description, cylinder
● For blank description, allowance
Allowance Allowance for pre-finishing - (only for ∇∇∇)
● Yes
● No
U1 Compensation allowance in X and Z direction (inc) – (only for allowance)
● Positive value: Compensation allowance is kept
● Negative value: Compensation allowance is removed in addition to finishing
* Unit of feedrate as programmed before the cycle call
Hidden parameters
Parameter Description
Residual material With subsequent residual material removal
SC Safety clearance
DI Continuous cut - (only for ∇)
Set machining area Set machining area limits
limits
N Number of grooves
10.3.11

Plunge-cutting rest (CYCLE952)

Function
The "Grooving residual material" function is used when you want to machine the material that
remained after grooving along the contour.
Turning
Operating Manual, 06/2019, A5E44903486B AB
– Version, absolute:
Cylinder dimension (abs)
– Version incremental:
Allowance (inc) to maximum values of the CYCLE62 finished part contour
– Allowance on the CYCLE62 finished part contour (inc)
U1 contour allowance
allowance
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Programming technology functions (cycles)
10.3 Contour turning
Value Can be set in SD
No
0
No
1
Unit
mm
mm
x
473