Removing A Tool From Multitool - Siemens SINUMERIK 840D sl Turning Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl Turning:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
13.15.4
Removing a tool from multitool
If the multitool was mechanically re-assigned (i.e. new tool were mounted), then old tools in the
tool list must be removed from the multitool.
To do this, the cursor is positioned at the line where the tool is located, which is to be removed.
When unloading, the tool is automatically saved in the tool list outside the magazine in the NC
memory.
Procedure
Turning
Operating Manual, 06/2019, A5E44903486B AB
2.
Position the cursor on the tool that you want to load into the mul‐
titool.
3.
Press the "Load" and "Multitool" softkeys.
The "Load to..." window opens.
4.
Select the required multitool and the multitool location to which you
wish to load the tool.
1.
The tool list is opened.
2.
Position the cursor on the tool that you would like to unload from
the multitool and press the "Unload" softkey.
- OR -
Position the cursor on the tool that you would like to remove and
delete from the multitool and press the "delete tool" softkey.
Tool management
13.15 Working with multitool
769
Advertisement
Table of Contents
