Siemens SINUMERIK 840D sl Turning Operating Manual page 271

Parameter Description
ZE3 Jaw dimension of the counterspindle with jaw type 2 - (only for spindle chuck data "yes" and
for a counterspindle that has been set up)
XR3 Tailstock diameter - (only for spindle chuck data "complete" and tailstock that has been set
up)
ZR3 Tailstock length - (only for spindle chuck data "complete" and tailstock that has been set up) mm
XA Outside diameter – (only for tube and cylinder)
XI Inside diameter (abs) or wall thickness (inc) – (only for tube)
N Number of edges – (only for polygon)
SW or L Width across flats or edge length – (only for polygon)
W Width of the blank - (only for centered cuboid)
L Length of the blank - (only for centered cuboid)
Turning
Operating Manual, 06/2019, A5E44903486B AB
Creating a G code program
8.6 Blank input
Unit
mm
mm
mm
mm
mm
mm
mm
271