Siemens SINUMERIK 840D sl Turning Operating Manual page 323

Parameters
F2
X2
Z2
F3
X3
Z3
Tool change
T
D
F4
X4
Z4
F5
X5
Z5
F6
X6
Z6
Turning
Operating Manual, 06/2019, A5E44903486B AB
Description
Feedrate for approach to the second position
Alternatively, rapid traverse
2nd position ∅ (abs) or 2nd position (inc)
2nd position (abs or inc)
Feedrate to approach the third position
Alternatively, rapid traverse
3rd position ∅ (abs) or 3rd position (inc)
3rd position (abs or inc)
WkzWpkt: Approach the tool change point from the last programmed position and
carry out a tool change
Direct: Tool is not changed at the tool change position, but at the last programmed
position
No: Tool is not changed
Tool name - (only for "direct" tool change)
Cutting edge number - (only for "direct" tool change)
Feedrate for approach to the fourth position
Alternatively, rapid traverse
4th position ∅ (abs) or 4th position (inc)
4th position (abs or inc)
Feedrate to approach the fifth position
Alternatively, rapid traverse
5st position ∅ (abs) or 5th position (inc)
5th position (abs or inc)
Feedrate to approach the sixth position
Alternatively, rapid traverse
6th position ∅ (abs) or 6th position (inc)
6th position (abs or inc)
Creating a ShopTurn program
9.16 Programming the approach/retraction cycle
Unit
mm/min
mm
mm
mm/min
mm
mm
mm/min
mm
mm
mm/min
mm
mm
mm/min
mm
mm
323