Simulating Machining; Simulation - Siemens SINUMERIK 840D sl Turning Operating Manual

Multi-channel machining
11.2 Multi-channel support
11.2.11

Simulating machining

11.2.11.1

Simulation

For classic lathes with main and counterspindle, up to two channels can be simultaneously
simulated.
You have the option of executing the programs together before the actual machining. In this
case, start, stop and reset - as well as the functions to control the program, act simultaneously
on all of the simulated channels.
Correction of the zero offsets for multi-channel data
If you use multi-channel data in the simulation, then the zero offsets are temporarily corrected
so that they match the blank and the spindle chuck data.
Preconditions
The function of the individual spindles and special axes, must be specified in the display
machine data set-up for the purpose.
Tool paths
Only the tool paths of the presently selected channel are displayed.
Procedure
696
2. Mark the required block that does not contain any other blocks and press
the "Form block" softkey.
3. Enter the required data in the "Form new block" window and press the
"Accept" softkey.
Note:
If a spindle has already been assigned to the marked block, you cannot
assign any spindle to the newly created block.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
1. Start the simulation.
2. Press the "Main spindle" softkey if you wish to view the main spindle.
- OR -
3. Press the "Counterspindle" softkey if you wish to view the counterspindle.
Operating Manual, 06/2019, A5E44903486B AB
Turning