Creating A Shopturn Program - Siemens SINUMERIK 840D sl Turning Operating Manual

Creating a ShopTurn program

9.5 Creating a ShopTurn program
9.5 Creating a ShopTurn program
Create a separate program for each new workpiece that you would like to produce. The
program contains the individual machining steps that must be performed to produce the
workpiece.
If you create a new program, a program header and program end are automatically defined.
ShopTurn programs can be created in a new workpiece or under the folder "Part programs".
Procedure
Creating a ShopTurn program
Filling out the program header
The retraction for a cycle ends at the safety clearance. Only the subsequent cycle moves to the
retraction plane. This enables a special approach/retraction cycle to be used.
298
1. Select the "Program Manager" operating area.
2. Select the desired storage location and position the cursor on the folder
"Part programs" or under the folder "Workpieces" on the workpiece for
which you wish to create a program.
3. Press the "New" and "ShopTurn" softkeys.
The "New machining step programming" window opens.
4. Enter the required name and press the "OK" softkey.
The name can contain up to 28 characters (name + dot + 3-character
extension). You can use any letters (except accented), digits or the un‐
derscore symbol (_). The "ShopTurn" program type is selected.
The editor is opened and the "Program header" parameter screen is
displayed.
5. Select a work offset.
6. Enter the dimensions of the blank and the parameter, which are effective
over the complete program, e.g. dimension units in mm or inch, tool axis,
retraction plane, safety clearance and machining direction.
Press the "Teach TC position" softkey if you want to set the actual posi‐
tion of the tool as a tool change point.
The tool's coordinates are transferred into parameters XT and ZT.
Teaching in the tool change point is only possible if you have selected the
machine coordinate system (Machine).
7. Press the "Accept" softkey.
The work plan is displayed. Program header and end of program are
created as program blocks.
The end of program is automatically defined.
Operating Manual, 06/2019, A5E44903486B AB
Turning