Siemens SINUMERIK 840D sl Turning Operating Manual page 471

Parameter Description
XD - (only for ∇ machining)
- (only for blank description, cylinder and allowance)
● For blank description, cylinder
● For blank description, allowance
ZD - (only for ∇ machining)
- (only for blank description, cylinder and allowance)
● For blank description, cylinder
● For blank description, allowance
Allowance Allowance for pre-finishing - (only for ∇∇∇)
● Yes
● No
U1 Compensation allowance in X and Z direction (inc) – (only for allowance)
● Positive value: Compensation allowance is retained
● Negative value: Compensation allowance is removed in addition to finishing
Set machining area Set machining area limits
limits
● Yes
● No
with limited machining area only, yes:
XA 1. Limit XA ∅
XB 2. Limit XB ∅ (abs) or 2nd limit referred to XA (inc)
ZA 1. Limit ZA
ZB 2. Limit ZB (abs) or 2nd limit referred to ZA (inc)
N Number of grooves
DP Distance between grooves (inc)
* Unit of feedrate as programmed before the cycle call
Turning
Operating Manual, 06/2019, A5E44903486B AB
– Version, absolute:
Cylinder dimension ∅ (abs)
– Version incremental:
Allowance (inc) to maximum values of the CYCLE62 finished part contour
– Allowance on the CYCLE62 finished part contour (inc)
– Version, absolute:
Cylinder dimension (abs)
– Version incremental:
Allowance (inc) to maximum values of the CYCLE62 finished part contour
Allowance on the CYCLE62 finished part contour (inc)
U1 contour allowance
allowance
Programming technology functions (cycles)
10.3 Contour turning
Unit
mm
mm
mm
mm
mm
mm
471