Siemens SINUMERIK 840D sl Turning Operating Manual page 366

Programming technology functions (cycles)
10.1 Drilling
Retraction
Retraction can be realized at the pilot hole depth or the retraction plane.
● Retraction to the retraction plane is realized with G0 or feedrate, programmable speed as
well as direction of rotation respectively stationary spindle.
● For retraction at the pilot hole depth, subsequent retraction and insertion are performed with
the same data.
Note
Direction of spindle rotation
The direction of spindle rotation is not reversed; however, where necessary, can be stopped.
Coolant
The technology and tools require that also in the G code, the control for the coolant is
supported.
● Coolant on
Switch on at Z0 + safety clearance or at the pilot hole depth (if a pilot hole is being used)
● Coolant off
● Programming in the G code
An executable block (M command or subprogram call), which can be programmed as string.
Procedure
Parameters in the "Input complete" mode
G code program parameters
Input
PL Machining plane
366
Always switch off at the final drilling depth
1. The part program or ShopTurn program to be processed has been cre‐
ated and you are in the editor.
2. Press the "Drilling" softkey.
3. Press the "Deep-hole drilling" and "Deep-hole drilling 2" softkeys.
The "Deep-hole drilling 2" input window opens.
● Complete
ShopTurn program parameters
Operating Manual, 06/2019, A5E44903486B AB
Turning