Siemens SINUMERIK 840D sl Turning Operating Manual page 484

Programming technology functions (cycles)
10.3 Contour turning
Parameter Description
Set machining area Set machining area limits
limits
● Yes
● No
with limited machining area only, yes:
XA 1st limit XA ∅
XB 2nd limit XB ∅ (abs) or 2nd limit referred to XA (inc)
ZA 1st limit ZA
ZB 2nd limit ZB (abs) or 2nd limit referred to ZA (inc)
N Number of grooves
DP Distance between grooves (inc)
* Unit of feedrate as programmed before the cycle call
484
Operating Manual, 06/2019, A5E44903486B AB
Unit
mm
mm
Turning