9.12
Changing program blocks
You can subsequently optimize the parameters in the programmed blocks or adapt them to new
situations, e.g. if you want to increase the feedrate or shift a position. In this case, you can
directly change all the parameters in every program block in the associated parameter screen
form.
Procedure
Turning
Operating Manual, 06/2019, A5E44903486B AB
1.
Select the program that you wish to change in the "Program Manager"
operating area.
2.
Press the <Cursor right> or <INPUT> key.
The work plan of the program is displayed.
3.
Position the cursor in the work plan at the desired program block and
press the <Cursor right> key.
The parameter screen for the selected program block is displayed.
4.
Make the desired changes.
5.
Press the "Accept" softkey.
- OR -
Press the <Cursor left> key.
The changes are accepted in the program.
Creating a ShopTurn program
9.12 Changing program blocks
311