Selecting A Magazine - Siemens SINUMERIK 840D sl Turning Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl Turning:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Several magazines
If you have configured several magazines, the "Load to ..." window appears after pressing the
"Load" softkey.
If you do not want to use the suggested empty location, then enter your desired magazine and
magazine location. Confirm your selection with "OK".
Multiple load points
If you have configured several loading points for a magazine, then the "Load Point Selection"
window appears after pressing the "Load" softkey.
Select the required loading point and confirm with "OK".
Unloading tools
13.5.7
Selecting a magazine
You can directly select the buffer memory, the magazine, or the NC memory.
Procedure
Turning
Operating Manual, 06/2019, A5E44903486B AB
1.
Place the cursor on the tool that you would like to unload from the mag‐
azine and press the "Unload" softkey.
2.
Select the required load point in the "Load Point Selection" window.
3.
Confirm your selection with "OK".
- OR -
Undo your selection with "Cancel".
1.
The tool list is opened.
2.
Press the "Magazine selection" softkey.
If there is only one magazine, you will move from one area to the next (i.e.
from the buffer memory to the magazine, from the magazine to the NC
memory, and from the NC memory back to the buffer memory) each time
you press the softkey. The cursor is positioned at the beginning of the
magazine each time.
- OR -
If there is more than one magazine, the "Magazine Selection" window
opens. Position the cursor on the desired magazine in this window and
press the "Go to ..." softkey.
The cursor jumps directly to the beginning of the specified magazine.
Tool management
13.5 Tool list
737
Advertisement
Table of Contents
