Siemens SINUMERIK 840D sl Turning Operating Manual page 671

Parameter
Work offset
Write to the
work offset
ZV
Blank
ZA
ZI
ZB
XA
XI
N
SW or L
W
L
S
Procedure
Turning
Operating Manual, 06/2019, A5E44903486B AB
Description
Selecting the work offset
● Yes
Parameter ZV is displayed
● No
Parameter ZV is not displayed
Z value of the work offset
The value exceeds the Z value in the selected work offset.
● Tube
● Cylinder
● Polygon
● Centered cuboid
Initial dimension
Final dimension (abs) or final dimension in relation to ZA (inc)
Machining dimension (abs) or machining dimension in relation to ZA (inc)
Outside diameter – (only for tube and cylinder)
Inside diameter (abs) or wall thickness (inc) – (only for tube)
Number of edges – (only for polygon)
Width across flats or edge length – (only for polygon)
Width of the blank - (only for centered cuboid)
Length of the blank - (only for centered cuboid)
Speed limitation of the counter-spindle
1. You have created programs for the multi-channel machining in the
job list and the parameter screen "Multi-channel data" is open in
the editor.
2. Enter the data for the cross-channel data.
3. Press the "Accept" softkey.
The multi-channel editor is opened and displays the programs that
have been created.
The cursor is positioned on an empty line before the cycle for the
job list (CYCLE208). You can also enter a comment.
Note:
Note that CYCLE208 must appear within the first 20 lines in job list
programs.
After the cycle call, enter the required initializations for the G code
program and add the program code.
Multi-channel machining
11.2 Multi-channel support
Unit
mm
mm
mm
mm
mm
mm
mm
mm
rev/min
671