Siemens SINUMERIK 840D sl Turning Operating Manual page 653

Parameter
Function
Workpiece transfer
Complete transfer
function
Coordinate
system
XP
ZP
Flush chuck
DIR
Clamping
S
α1
Z1
ZR
FR
Fixed
stop
Turning
Operating Manual, 06/2019, A5E44903486B AB
Description
You can select one of the following functions:
● Complete transfer
● Gripping
● Withdrawing
● Machining side
● Main spindle in counter-spindle
● Counter-spindle in main spindle
Gripping
● Machine coordinate system (MCS)
The park position is specified in the machine coordinate system. Teaching in
the park position and angular offset is only possible in the machine coordinate
system.
● Workpiece coordinate system (WCS)
The park position is specified in the workpiece coordinate system.
Park position of tool in X direction (abs)
Park position of tool in Z direction (abs)
Flush counter-spindle chuck
● Yes
● No
Direction of rotation
● Spindle rotates clockwise
● Spindle rotates counter-clockwise
● Spindle does not rotate
Clamping both spindles (only if spindles are not turning)
●
Clamping open
●
Clamping closed
Spindle speed – (only when the spindle rotates)
Angular offset
Transfer position (abs.)
Position, feedrate reduction (abs or inc)
Position from which a reduced feedrate is used.
Reduced feedrate
Travel to fixed stop
● Yes
The counter-spindle stops at a defined distance away from transfer position
Z1 and then traverses with a defined feedrate up to the fixed stop.
● No
The counter-spindle traverses to the transfer position Z1.
Withdrawing
Programming technology functions (cycles)
10.7 Additional cycles and functions in ShopTurn
Unit
mm
mm
rev/min
Degrees
mm/rev
653