Configure Snmp Dialog Box - Enable Authorization Traps; Configure And Enable E-Mail Notification - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

2. To enable transmission of trap messages to configured SNMP management
Figure 18: Configure SNMP dialog box — Enable Authorization Traps
3. Click Activate to save the information and close the dialog box.

Configure and Enable E-mail Notification

Perform this procedure to configure and enable e-mail addresses and simple mail
transfer protocol (SMTP) server addresses to receive e-mail notification of switch
(and other managed product) events. The addresses must be configured at the
HAFM application, then enabled. See
Notification
To configure and enable e-mail and SMTP server addresses:
1. At the Product View page, choose Maintenance > Configure E-Mail. The
Edge Switch 2/24 Installation Guide
c. Type the IP address or DNS host name of the trap recipient (SNMP
management workstation) in the associated Trap Recipient field. Use 32
alphanumeric characters or less. It is recommended the IP address be
used.
d. The default user datagram protocol (UDP) port number for trap recipients
is 162. Type a decimal port number in the associated UDP Port Number
field to override the default.
workstations, click Enable Authorization Traps. A check mark displays in
the box when transmission is enabled
for instructions on testing this notification feature.
Configure E-Mail dialog box displays
Installing and Configuring the Edge Switch 2/24
(Figure 18).
"Test Remote Notification" on
(Figure 19).
Test Remote
63