Table of Contents
Advertisement
Back up HAFM configuration data
It is important to back up the HAFM configuration data. This data is used to restore the HAFM
appliance operating environment in case of hard drive failure. Refer to the HP StorageWorks
HA-Fabric Manager appliance installation guide for instructions on backing up the HAFM
configuration data.
Once the HAFM configuration data is backed up, go to
page 65.
Configure Open Systems management appliance
For complete procedures on configuring this optional feature, refer to HP StorageWorks Edge Switch
Element Manager user guide.
Configure FICON management appliance
For complete procedures on configuring this optional feature, refer to HP StorageWorks Edge Switch
Element Manager user guide.
Configure feature key
For complete procedures on configuring this feature, refer to HP StorageWorks Edge Switch Element
Manager user guide.
Configure Open Trunking
This option is only available if the optional Open Trunking feature is installed. Selecting this option
opens the Configure Open Trunking dialog box. For details on enabling Open Trunking and
configuring such parameters as congestion thresholds for ports, event notification options, and low
BB credit threshold, refer to the HP StorageWorks Edge Switch Element Manager user guide.
Enable Embedded Web Server
Use the following steps to enable EWS:
1.
At the Hardware View page, select Configure > Enable Web Server. Selecting Enable Web
Server automatically places a check mark in the check box.
2.
Select Enable Web Server again to remove the check mark and disable the EWS interface.
When disabled, remote users cannot access the interface.
For complete information on using the EWS, see
Enable Telnet
Use the following steps to enable Telnet:
1.
At the Hardware View, select Configure > Enable Telnet. Selecting Enable Telnet automatically
places a check mark in the check box.
2.
Select Enable Telnet again to remove the check mark and disable Telnet access. When disabled,
remote users cannot access the switch through Telnet.
64
Installing and configuring the Edge Switch 2/32
"Connect cables to Fibre Channel
"Using the Embedded Web
ports" on
Server" on page 71.
Advertisement
Table of Contents
