Body Guide; Body-Up Retention Cable - Komatsu 830E-AC Shop Manual

BODY GUIDE

1. Body guide wear points should be inspected
each time a body pad inspection is performed.
(Refer to Figure 3-5.) The body guide should be
centered between the wear plates (3), with a
maximum gap of 4.8 mm (0.19 in.) at each side
when new.
2. If gap becomes excessive, install new parts.
FIGURE 3-5. BODY GUIDE
1. Dump Body
2. Body Guide
B03025
3. Body Guide Wear
Plates
Dump Body

BODY-UP RETENTION CABLE

To avoid serious personal injury or death, the
body up retention cable must be installed any-
time personnel are required to perform mainte-
nance on the vehicle with the dump body in the
raised position.
1. To hold the dump body in the up position, raise
the body to its maximum height. (Refer to Fig-
ure 3-6.)
2. Remove the cable (3) from its stored position on
the body and install between the rear body ear
(1) and the axle housing ear (4).
FIGURE 3-6. BODY-UP CABLE INSTALLATION
1. Rear Body Ear
Structure
2. Cable Storage
3. Secure the cable clevis pins with cotter pins.
4. After maintenance work is completed, reverse
the above procedure to remove cable assembly
and place it in the storage position.
3. Cable
4. Axle Housing Ear
Structure
B3-7