Komatsu 830E-AC Shop Manual page 265

Epoxy Adhesive
Master Bond, Inc.
154 Hobart Street
Hackensack, NJ 07601 USA
Phone: 201-343-8983
Fax: 201-343-2132
www.masterbond.com
Epoxy adhesive, EP11HT, is a one component, heat
curing, structural epoxy adhesive with high shear
strength, easy handling, and high temperature resis-
tance. Cures at elevated temperatures, e.g. 90-120
minutes at 121°C (250°F) or 60-90 minutes at 149°C
(300°F). The minimum cure temperature is 121°C
(250°F). EP11HT attains tensile shear strengths in
excess of 22753 kPa (3,300 psi) and forms rigid and
dimensionally stable bonds. The service temperature
range is -51°C to 204°C (-60°F to 400°F). As a one
part system, it does not require mixing prior to use
and has an unlimited working life at room tempera-
ture. EP11HT bonds well to a wide variety of sub-
strates, including metals and most plastics. It has
excellent resistance to a wide range of chemicals
including acids, bases, oils, salts, and many solvents.
This adhesive is 100% reactive and does not contain
any solvents or volatiles. The standard color is tan.
The cured adhesive fully meets the requirements of
MIL-MMM-A-132.
Liquid Threadlockers
Loctite 222 Low Strength Threadlocker is an anaero-
bic sealant. This low-strength threadlock is used for
small screws less than 6 mm (.25 in.) in diameter.
The parts can be separated using hand tools.
Henkel Corporation
1001 Trout Brook Crossing
Rocky Hill, Connecticut 06067 USA
Phone: 860-571-5100
Internet: www.loctite.com
D10003 07/06
Elastoplastic Silicone Resin
Dow Corning 1-2577 Low VOC RTV is a one-part
clear, RTV cure with mild heat acceleration possible.
It has a hard slick finish with abrasion resistance, sol-
vent-borne with low VOC which is ozone-safe. This
silicon meets UL and MIL Specs and contains a UV
indicator.
Typical Properties:
Viscosity/Flowability
(cps or mPa sec) = 1,250;
Durometer = 25 D;
Specific Gravity = 0.88;
RT Tack Free Time = 6 minutes;
Room Temp Cure Time = 60 minutes;
Heat Cure Time = 2 minutes @ 60°C (140°F;
Agency Listing = UL 94 V-0 or HB & 746C / Mil Spec;
Dielectric Strength, Volts/mil = 340;
Dielectric Strength kV/mm = 13.4;
Volume Resistivity ohm-cm = 1.9E+14
Dow Corning Corporation
Corporate Center
PO Box 994
Midland MI 48686-0994 USA
Phone: 989-496-7881
Fax: 989-496-6731
www.dowcorning.com
Battery Charging Alternator D10-35