(Page 1 of 2)
FOR: 730E, 830E, 930E & 960E DUMP TRUCKS
Item
To be checked when
No.
1. Key switch OFF
2. Connect PC to VHMS controller
3. Key switch ON
4. Start VHMS Setting Tool program Select "VHMS Setting", then "Set up & All clear".
5. Initial setup of VHMS controller
Machine Information Setting(1)
6. Machine Information Setting (2)
7. Date & Time Setting
8. GCC Setting
9. Setting Data
10. Setting of Payload Meter
D14-6
VHMS INITIALIZATION CHECK LIST
Machine Model Number
Machine Serial Number
Service Meter Reading
Engine Serial Number
Alternator Serial Number
VHMS Serial Number
OrbComm Serial Number
Are they properly connected?
Check operation of controller LED
(after segment rotation, display to count-up).
Is Product Group correct? (Dump truck)
Is Machine Model correct? (ex. 930E)
Is Type correct? (ex. -2)
Is Variation Code correct? (ex. SE)
Is Serial Number correct?
Is Engine Model - Type correct?
Is Engine Serial Number correct?
Is Time Zone correct?
Is Date correct?
Is Time correct?
Is DST (daylight saving time) correct?
Is correct GCC code selected for location?
Verify Setting Data is Correct.
Set PLM time ± 2 minutes of VHMS time.
Start Time (set to 0)
Interval (set to 1)
VHMS - Forms
Date of set-up
(MM/DD/YY)
Distributor and
Branch
Person performing
initialization
Check Item
/
/
Results
Yes
No
01/06 D14003