Komatsu 830E-AC Shop Manual page 168

FIGURE 7-26.
24. Support the bearing retainer as close as
possible to the bearing bore. Be careful not to
damage the retainer/seal assembly. Press the
shaft out of bearing (14) using tooling (E).
FIGURE 7-27.
25. Remove oil seal (10) from bearing retainer (11).
C7-14
26. Use tooling (E) to press rear bearing (14) out of
rear bearing retainer (11).
27. Use a chisel to make three indentations in wear
sleeve (4).
approximately 120 degrees apart from one
another. Remove the wear sleeve.
NOTE: Use caution when using the chisel. Do not cut
through the sleeve. Damage to the shaft can cause
future leaks.
Fan Clutch
FIGURE 7-28.
FIGURE 7-29.
The indentations should
C07001
be