Table of Contents
Advertisement
FIGURE 2-14. INSTALL JUMPER
2. The Linear Detection Wire
a. Using the furnished text kit, proceed to the
end of the last length of detection wire.
Remove the plugged blank connector (Fig-
ure 2-14) and install the jumper assembly.
NOTE: Retain plugged connector to be reinstalled
after testing is completed.
b. With jumper in place, screw squib connector
into receptacle on test module (Figure 2-15).
Test module light should immediately illumi-
nate. This test confirms that the wire is prop-
erly installed and will function as designed. If
test module light does not illuminate on test
module, refer to the "Troubleshooting" sec-
tion.
FIGURE 2-15. INSTALL TEST MODULE
ASSEMBLY
M2-8
c. Proceed to the end of the last length of
detection wire and remove the jumper
assembly (Figure 2-15). Finally, put original
plugged blank connector onto detection wire.
The test module light should immediately go
out. If light does not go out refer to "Trouble-
shooting".
d. Remove the test kit from the system by, first,
disconnecting the squib connector from the
test module (Figure 2-17). NOTE: Retain
these components for possible later use.
Remove jumper to prevent fire suppression sys-
tem from discharging when squib is installed in
electric detection and actuation system.
FIGURE 2-16. REMOVE JUMPER ASSEMBLY
FIGURE 2-17. REMOVE INDICATOR LIGHT
Fire Control Systems
! CAUTION !
ASSEMBLY
M02005
Advertisement
Chapters
Table of Contents
