Komatsu 830E-AC Shop Manual page 885

42. Remove the EJ3057 harness from the left front
suspension junction box, TB42-A and TB42-B.
43. Wait at least 1 minute and remove the EJ3057
harness from the left-rear connections in the
rear junction box, TB61-B and TB61-C.
44. Wait at least 1 minute and remove the EJ3057
harness from the right-rear connections in the
rear junction box, TB61-A and TB61-C.
45. Wait at least 1 minute and remove the EJ3057
harness from the right-front connections in the
right-front junction box, TB61-B and TB61-C.
46. Wait at least 1 minute.
47. From the main menu of the PC software press
the "Connect to Payload Meter" button.
48. From the Connection Menu select "Display
Active Alarms". Confirm that the four alarms
displayed occurred in the proper order;
Left-front suspension low
Left-rear suspension low
Right-rear suspension low
Right-front suspension low
49. Close all screens and disconnect the laptop
from the PLMIII system.
M20008 02/05
PLMIII CHECKOUT PROCEDURE
CONFIRMATION
Flashburn Programming
General Instructions:
Before beginning, be sure the ".kms" file required to
program the product and you know where to find it on
your computer.
Programming will reset all the truck configuration
information.
NOTE: Before starting this procedure, record the
Payload Meter configuration information.
This information can be found using the Payload
Data Manager software. After programming, it will be
necessary to restore this information in the payload
meter configuration.
1. Turn off power to the payload meter by turning
the key switch OFF.
2. Start the "Flashburn" software installed on the
laptop.
Flashburn
1. Power
OFF
2. Select
Port
3. Select
File
4. Power
ON
3. Confirm that the payload meter power is OFF
and press "NEXT".
Payload Meter III
Before programming, power must be
turned off to the target device. Be sure
the power is turned off before continuing.
< Back Next > Cancel
M20-57