Komatsu 830E-AC Shop Manual page 803

Installation Procedure for Squib
After all testing has been completed and all test kit
components removed, proceed to arm the system.
FIGURE 2-18.
FIGURE 2-19.
FIGURE 2-20.
M02005
Using wrench, insert squib into upper right inlet hole
on actuator body and firmly tighten (Figure 2-18).
After installing squib into actuator body, loosen pro-
tective shipping cap from squib and remove bridge
(Figure 2-19).
Always install squib into actuator body first,
before installing connector onto threaded body
of squib. Possible injury could result if squib was
actuated outside of actuator body.
Install squib connector onto threaded stud of squib
(Figure 2-20). Hand tighten as firmly as possible.
Placing the Electric Detection & Actuation
System Into Service
To place the electric detection and actuation system
into service, proceed as follows:
1. Check all fasteners for tightness. Insure jam nut
on actuator body is securely tightened.
2. Before installing actuator cartridge, push man-
ual puncture lever several times to insure
smooth operation.
3. Insert ring pin in hole and attach lead wire seal
(See Figure 2-21).
FIGURE 2-21. INSTALL ACTUATOR CARTRIDGE
4. Insert LT-5-R cartridge (PB0674) into lower
actuator body and hand tighten firmly.
5. Record date that system was placed in service.
Fire Control Systems M2-9