Table of Contents
Advertisement
4. Use clutch hub holding tool (2, Figure 4-18),
spanner wrench (J-9403), or the equivalent to
hold clutch hub (3) while removing the locknut.
It is recommended that the locknut be replaced
after it has been removed.
FIGURE 4-18.
1. Thin Wall Socket
2. Clutch Hub Holding Tool
3. Clutch Hub
N04031 10/06
5. Thread clutch plate and hub assembly remover
(2, Figure 4-19) into the hub of clutch assembly
(1). Hold the body of the remover with a wrench
and tighten the center screw to pull the clutch
plate and hub assembly from the compressor.
1. Clutch Assembly
6. Remove square key (1, Figure 4-20) from the
keyways.
1. Square Key
Operator Comfort
FIGURE 4-19.
2. Clutch Plate & Hub
Assembly Remover
FIGURE 4-20.
2. Keyway in Shaft
N4-31
Advertisement
Chapters
Table of Contents
