Table of Contents
Advertisement
FIGURE 3-10.
1. Screws
Remove the screw at the lower end of the window
channels. It is necessary to pull the rubber felt insert
(2, Figure 2-10) out of the channel in order to be able
to remove the screws.
9. Remove the trim material covering the screws
holding the window frame to the door. Remove
screws (1, Figure 2-11) holding window frame
to the door.
Note: Screws along the bottom of window frame may
be shorter than along the top and sides.
FIGURE 3-11.
1. Screws
N02019
2. Rubber Felt Insert
Truck Cab
10. Lift door glass up in the frame (1, Figure 2-12)
so that it is near the top. Holding the glass in
place, tilt frame out at the top. Lift frame and
glass straight up and out of door.
Bracket (2, Figure 2-12) at bottom of glass must
clear the door frame, if still on glass.
FIGURE 3-12.
1. Window Frame
11. Move window glass and frame to an area where
the glass can be removed. Slide the glass down
and out of the window channels.
12. Before installing new window glass, first inspect
the window frame. In each corner there is an "L"
shaped bracket with 2 screws in it to hold the
corners of the frame together. Check the
screws (1, Figure 2-10) to be sure they are tight.
Also be sure the rubber felt insert in the window
channels is in good condition. Replace, if nec-
essary.
2. Window Bracket
N2-11
Advertisement
Chapters
Table of Contents
