Table of Contents
Advertisement
Service
Complete instructions covering the disassembly,
assembly and maintenance of the engine and its
components can be found in the engine manufac-
turer's service manual.
Installation
1. Align engine to subframe and install front
mounting cap screws and lockwashers (5, Fig-
ure 4-7). Align and install rear engine mounting
cap screws and lockwashers (2) through cradle
structure, but do not tighten at this time. Tighten
front mount cap screws to 465 N·m (345 ft lbs)
torque.
1. Cradle Structure
2. Cap Screws and Lockwashers
C04034
2. Install alternator on engine following instruc-
tions for "Engine/Alternator Mating".
3. Tighten rear engine mounting cap screws (2) to
465 N·m (345 ft lbs) torque after alternator is
installed.
4. Adjust setscrew (3, Figure 4-1) to equalize gap
(5) between cradle structure (1) and subframe
(4) at left and right side. Lock setscrew with jam
nut (2).
FIGURE 4-8. ENGINE MOUNTING
3. Engine Module Subframe
4. Engine
Power Train
5. Cap Screws and Lockwashers
6. Engine Lift Points
C4-9
Advertisement
Chapters
Table of Contents
