Table of Contents
Advertisement
5. Remove hex head bolt (23) using a 13 mm
socket. Also, remove Bellville washer (24) and
flat washer (25).
FIGURE 10-154.
23. Hex Head Bolt
24. Bellville Washer
6. Identify and mark the wiring terminals for proper
reassembly. These terminals must be reinstalled
in the same location as they were removed.
The order of the connections from top to bottom is:
rectifier terminal (1)
rectifier terminal (1),
B+/sense terminal (2),
thermal switch terminal (3),
flat washer,
Bellville washer, and
bolt
FIGURE 10-155.
D10003 07/06
25. Flat Washer
Battery Charging Alternator
7. Remove thermal switch (22).
a. Reposition the two insulation sleeves to
expose the wiring connections.
b. Remove the heat shrink insulation from both
wiring connections.
c. Unsolder each wire from the wiring terminal
sleeves.
FIGURE 10-156.
FIGURE 10-157.
D10-77
Advertisement
Chapters
Table of Contents
