Table of Contents
Advertisement
FIGURE 7-40.
FIGURE 7-41.
3. Using tooling (A), press front (long) sleeve
bearing (44) into the fan mounting hub until the
tool contacts the shoulder of the hub. Ensure
the correct bearing is installed. There are two
sleeve bearings, and each one must be
installed in the proper area of the hub to ensure
the lube passage is not restricted. Refer to
Figure 7-40.
C07001
4. Turn the hub over on the bed of the press.
Using tooling (B), press rear sleeve bearing (41)
into the fan mounting hub until the tool contacts
the shoulder of the hub.
Fan Clutch
FIGURE 7-42.
C7-21
Advertisement
Chapters
Table of Contents
