Table of Contents
Advertisement
VHMS INITIALIZATION PROCEDURE
When a new VHMS equipped machine is being
assembled, there are several procedures to perform
in order to initialize the VHMS system. Following the
procedures will ensure a smooth initialization pro-
cess which should not take longer than an hour to
complete. To ensure the initialization process has
been completed properly, check off each item on the
list below as it is done. It is important to complete the
entire procedure at one time. Submitting a data
download with a date and SMR that does not match
the VHMS Initialization form will not allow the system
to be initialized.
NOTE:
The
interface
operational before initializing the VHMS controller.
The initialization procedure consists of the following:
1. VHMS Controller Setup Procedure
2. VHMS Snapshot Procedure
3. VHMS Download Procedure
4. Location Of Download Files
5. VHMS FTP Upload Procedure
6. VHMS Initialization Forms
D12-6
module
must
be
fully
VHMS SOFTWARE
1. VHMS CONTROLLER SETUP
PROCEDURE
VHMS Setting Tool software program
1. Start the VHMS Setting Tool software program.
There will be three choices to choose from.
• Use the [VHMS Setting] function to initialize a
machine or change a machine's settings.
• Use the [When VHMS needs to be replaced]
function when replacing a machine's VHMS
controller.
• Use the [Review setting information] function
when only needing to view a machine's settings.
Select Operation
2. Select VHMS Setting, then click [Next].
D12004
Advertisement
Chapters
Table of Contents
