Komatsu 830E-AC Shop Manual page 886

4. Confirm the proper communications port for the
programming laptop. This is usually COM 1.
Press "NEXT".
Flashburn
1. Power Select the serial communications port to
use between the computer and the
OFF
target device. For most computers this
2. Select will be COM 1.
Port
COM 1
3. Select
File
4. Power
ON
< Back
5. Press "BROWSE" and select the ".kms" file to
program into the payload meter. Press "NEXT".
Flashburn
1. Power Select the file that will be used to
program the target device. This file will
OFF
end with the ".KMS" extension.
2. Select
Comm Port: COM 1
Port
Filename:
3. Select
File
4. Power
ON
< Back
6. When instructed, turn the key switch ON in
order to power-up the payload meter. The PC
will begin to reprogram the payload meter. This
process takes approximately 5 minutes.
M20-58
Next > Cancel
*.KMS Browse
Next > Cancel
Payload Meter III
Flashburn
1. Power
Turn on power to the target device. This
will start the programming process.
OFF
Comm Port:
2. Select
Filename:
Port
Steps
3. Select
Connection:
File
Preparation:
4. Power
Programming:
ON
Verification:
< Back
7. After successful programming, turn the key
witch OFF.
8. Wait 20 seconds and turn the key switch ON.
9. The payload meter will need to be configured as
instructed in the manual using the Payload Data
Manager software on the laptop computer.
COM 1
071000A.KMS
Status
Complete
Complete
Complete
Complete
61 %
Cancel
02/05 M20008