Komatsu 830E-AC Shop Manual page 525

®
The HYDRAIR II suspensions are hydro-pneumatic
components containing oil and nitrogen gas. The oil
an gas in the four suspensions carry the gross truck
weight less wheels, spindles and final drive assem-
bly. The rear suspension cylinders consist of two
basic components; a suspension housing attached to
the rear axle housing, and a suspension rod attached
to the frame.
®
The HYDRAIR II suspension cylinder requires only
normal care when handling as a unit. However, after
being disassembled these parts must be handled
carefully to prevent damage to the machined sur-
faces. Surfaces are machined to extremely close tol-
erances and are precisely fitted. All parts must be
completely clean during assembly.
FIGURE 3-1. REAR SUSPENSION INSTALLATION
1. Mounting Pins
2. Piston Rod Shield
H03024
REAR SUSPENSIONS
3. Suspension Cylinder
Rear Suspensions
Removal
TABLE 1. TOOL LIST FOR SUSPENSION PIN
REMOVAL
Part Number Description
EJ2847 Pin Removal Tool
EJ2848 Cylinder
EJ2849 Hand Pump
EJ2850 Shackle
Cap Screw
VN2707 (0.625-11UNC x 2.75
in)
NOTE: Suspension mounting pins must contain
threaded holes at the inboard end of each pin in
order to use the removal tools listed above. If the
pins do not contain the necessary holes, new pins
may be purchased, or a rework of the pins is neces-
sary. Refer to Figure 3-5 for pin rework details.
1. Remove cap screws, washers, and metal shield
(2, Figure 3-1) from the suspension.
2. Remove charging valve cap, (1, Figure 3-2)
loosen small hex (4) on charging valve and turn
counterclockwise three full turns to unseat valve
seal. Connect suspension charging kit.
Make certain only the swivel nut turns. Turning
the complete charging valve assembly may result
in the valve assembly being forced out of the
suspension by the gas pressure inside.
3. If necessary, charge the suspension to be
removed with dry nitrogen until the rod is
exposed approximately 127 mm (5.0 in.).
Quantity
2
1
1
2
4
H3-3