Vhms Forms; Vhms Initialization Check List - Komatsu 830E-AC Shop Manual

The preferred method to submit this form is in
electronic format. This check list and initialization
form are available in PDF format, where the
information can be typed into the form. The form
should then be saved using the model, serial number
and "VHMS Initilization" to create the file name.
Example: 930E-3SE-A30300-VHMS Initilization.pdf.
The following instructions will help ensure an
accurate and complete form.
When a new machine equipped with the Vehicle
Health Monitoring System (VHMS) has been
assembled, there are several procedures to perform
in order to initialize the VHMS system. Following the
procedures in the order listed will ensure a smooth
initialization process which should not take longer
than one hour to complete. Check off each item on
the list below as it is done. It is important to complete
the entire procedure at one time. Submitting the
download data with a date and service meter reading
(SMR) that do not match the rest of the forms will not
allow the system to be initialized.

1. __ VHMS Initialization Check List

2. __ VHMS Data Download
3. __ VHMS Initialization Form
Orbcomm terminal activation can take up to two
weeks. For this reason, it is important to complete
these forms and submit them as early as possible
after new machine assembly.
VHMS INITIALIZATION CHECK LIST
This form is used as a check list during the
initialization process. Fill in all information. All
questions should be answered with a YES. If not,
determine the cause and repair as required.
Each machine model will have a different VHMS
Initialization Check List. Use the correct form for the
model of machine being setup.
1. With the key switch OFF, record all data for
item 1.
D14003 01/06

VHMS FORMS

2. Using a serial cable, connect a laptop PC to the
VHMS controller.
3. Turn the key switch ON, check operation of the
LED lights.
4. Start the VHMS Setting Tool program.
a. At the Select Operation screen, select the
"VHMS Setting" option, then click [Next].
b. Select the "Set up & All clear" option, then
click [Next].
5. At the Machine Information Setting (1) screen:
a. Is Product Group correct?
b. Select the correct Machine Model.
c. Select the correct Machine Type.
d. Select the correct Machine Variation Code.
e. Enter the machine serial number.
f. Click [Next].
6. At the Machine Information Setting(2) screen:
a. Verify information is correct.
b. Enter engine serial number.
c. Then click [Next].
7. At the Date & Time Setting screen:
a. Select the correct time zone.
b. Enter the correct date.
c. Enter the correct time.
d. Select Daylight Savings Time (DST) if
necessary.
e. Click [Next].
8. At the GCC Setting screen:
a. Select the correct country setting.
b. Click [Next].
VHMS - Forms D14-3