Table of Contents
Advertisement
FIGURE 2-2. EXHAUST DUCTS
(Heated Body Exhaust Shown)
1. LH Exhaust Duct
2. Cap Screws
3. RH Exhaust Duct
11. Remove clamps (6, Figure 2-3) securing the air
intake ducts (3) to turbochargers (4). Remove
clamps at hump hoses (1). and remove air
intake ducts. Cover inlets on turbochargers and
ducts to air cleaners to prevent contamination.
12. Remove upper radiator support struts (12, Fig-
ure 2-4).
13. Disconnect grounding strap located near the
front subframe mount.
C02027
4. Support Clamp
5. "V" Band Clamp
6. Frame Rails
Power Module
14. Remove cap screws and washers securing
cover (10, Figure 2-4) to grille at center of front
bumper and remove. Remove cap screws and
lockwashers (9) securing front subframe sup-
port to main frame.
Install safety chain around the front engine sub-
frame cross member and main frame to prevent
the power module from rolling forward when the
subframe rollers are installed.
15. Remove cap screws (4, Figure 2-4) and caps
(3) securing subframe mounting bushings to the
subframe support bracket (6) at rear of sub-
frame.
16. Check engine and alternator to make sure all
cables, wires, hoses, tubing and linkages have
been disconnected.
17. Remove the mounting hardware at the diagonal
ladder mounting pads. Lift the diagonal ladder
from the truck and move it to a storage area.
Federal
regulations
conditioning
system
atmosphere.
An
approved
station must be used to remove the refrigerant
from the air conditioning system.
18. Refer to Section N, Operator Comfort, for the
procedures required to properly remove the
refrigerant from the air conditioning system.
After
the
system
disconnect the refrigerant hoses to the cab at
the compressor and receiver/drier.
NOTE: System contains HFC-134A refrigerant.
prohibit
venting
air
refrigerants
into
the
recovery/recycle
has
been
discharged,
C2-5
Advertisement
Chapters
Table of Contents
