Table of Contents
Advertisement
7. Lubricate the spiral ring with Komatsu grease
XA3401. Wind new spiral ring (5) into the
groove around pulley bushing (4).
FIGURE 10-125.
4. Pulley Bushing
8. Compress spiral ring (5) and install pulley bush-
ing assembly (4) into the outside of drive end
housing (20). Position the thickest flange of the
pulley bushing facing up (towards the outside of
the alternator).
FIGURE 10-126.
4. Pulley Bushing
Assembly
5. Spiral Ring
D10003 07/06
5. Spiral Ring
20. Drive End Housing
Battery Charging Alternator
9. Guide the two field coil leads through the open-
ing in the drive end housing and into the control
housing.
FIGURE 10-127.
D10-69
Advertisement
Chapters
Table of Contents
