Komatsu 830E-AC Shop Manual page 910

13. Slide the new window glass into the window
frame glass channels. Move the glass to the top
of the frame.
14. Lift window frame, holding glass at the top of the
frame, and lower the assembly into the door.
FIGURE 3-13.
1. "L" Shaped Brackets
Be sure the one channel (5, Figure 2-14) which is
next to the door latch passes to the inside of the
latch assembly (4).
15. Lower glass in frame and support it as seen in
Figure 2-9.
N2-12
16. Reinstall window frame screws which holds it to
the door frame.
Screws along the bottom of window frame may
be shorter than the ones along the sides and top.
These screws must be used in this area to pre-
vent the window glass from being scratched or
cracked. See Figure 2-11.
17. Install trim material over the top of screws that
holds the window frame to the door. Use a flat
blade screwdriver to assist with installing the
trim material. See Figure 2-15. Be careful not to
cut the retainer lip on the trim material.
1. Cap Screw & Nut
2. Mounting Screws -
Latch
Truck Cab
FIGURE 3-14.
3. Mounting Screw - Out-
side Door Handle
4. Latch Assembly
5. Window Frame
N02019