Table of Contents
Advertisement
FIGURE 10-35.
50. Spiral Ring
Pulley Removal
1. Remove pulley (3, Figure 10-24) from the drive
end by removing nut (1) using an air impact
wrench and a 30 mm socket. Also, remove
washer (2) and woodruff key (49).
FIGURE 10-36.
1. Nut
2. Washer
NOTE: Removal of the pulley may require a three
jaw gear puller.
D10-42
65. Fan
49. Woodruff Key
Battery Charging Alternator
Anti-Drive End Housing Removal
1. Scribe a single mark on side of shell (58) and
drive end housing (20). Scribe a double mark on
the side of shell (58) and anti-drive end housing
(64). This will ensure the proper reassembly of
the end housings.
FIGURE 10-37.
20. Drive End Housing
58. Shell
64. Anti-Drive End
Housing
D10003 07/06
Advertisement
Chapters
Table of Contents
