Komatsu 830E-AC Shop Manual page 330

VHMS SYSTEM SET UP
The following topics are covered in detail.
INTERFACE MODULE
• Flashburn Program
• Interface Module Application Code
• Interface Module Realtime
Software
VHMS CONTROLLER
• VHMS Tool Box
• VHMS Setting Tool
• VHMS Initialization Procedure
• VHMS Snapshot Procedure
• VHMS Download Procedure
• Location of Download Files
• VHMS FTP Upload Procedure
• VHMS Initialization Forms
• When Replacing a VHMS Controller
INTERFACE MODULE
FLASHBURN PROGRAM
Installation
The Flashburn program is used to install the applica-
tion code into the interface module controller.
1. Save the file EJ3055-2.exe to local drive on a
laptop PC.
2. Double click on the "EJ3055-2.exe" file to
extract the files to a directory (such as C:\temp).
3. Inside that directory,
"Setup.exe" to install the Flashburn program.
4. Follow the on screen prompts to install the pro-
gram.
D12-4
Data Monitor
double click on
VHMS SOFTWARE
INTERFACE MODULE APPLICATION
CODE
Installation
The application code is truck specific software that is
installed into the interface module. Application code
is installed using the Flashburn program.
1. Using a laptop PC, save the application code
files to a folder on a local hard drive (such as
C:\temp).
•830E-AC - File name is EM2126-0.exe
2. Double click on the correct application code file
so it will extract the file. Chose a folder on a
local hard drive to save the file into (such as
C:\temp).
•830E-AC - File name is EM2126-0.kms
3. Using a serial cable, connect the laptop PC to
the IM-Diag connector located near the inter-
face module.
4. Start the Flashburn program.
5. Select [Download Application to Product].
6. Be sure the power is off to the interface module.
Then click [Next].
7. Select the correct COM port. Then click [Next].
8. Select the correct ".KMS" file. Then click [Next].
Flashburn will now install the application code into
the interface module.
D12004