Komatsu 830E-AC Shop Manual page 297

Drive End Housing Installation
1. Place shell assembly (58) into the support
stand with the drive end facing up.
FIGURE 10-119.
58. Shell Assembly
DO NOT damage the stator windings or studs
while repositioning the alternator.
2. Align the scribed marks on the drive end hous-
ing and the shell. Install the rotor shaft and
housing assembly onto the shell. A rod can be
used to verify the mounting tabs on the shell
and the drive end housing are properly aligned.
FIGURE 10-120.
D10003 07/06
73. Support Stand
Battery Charging Alternator
3. As the drive end housing is installed, guide the
two field coil leads and the six stator phase
leads through the proper openings in the drive
end housing.
NOTE: If necessary, install new terminal ends on the
wires. On the stator phase leads cut the wires to
length, strip the correct amount of wire insulation,
install insulating sleeves over the wires, and solder
on the new terminal ends. On the new field coil leads,
cut the wires to length, strip the correct amount of
wire insulation, and crimp on the new terminal pins.
FIGURE 10-121.
D10-67