Komatsu 830E-AC Shop Manual page 301

13. Install cover plate (7). Apply thread lock com-
pound (Loctite) and install six Torx screws (6)
using a T20 Torx bit. Tighten the screws to 3 N·m
(30 in. lb).
FIGURE 10-131.
6. Screws
®
14. Apply Dow Corning
equivalent, onto the cover before installing.
Install control unit cover (21). Apply thread lock
compound (Loctite) with five Torx screws (6)
using a T20 Torx bit. Tighten to 3 N·m (30 in.
lb).
FIGURE 10-132.
6. Screws
D10003 07/06
7. Cover Plate
1-2577 low VOC RTV, or
21. Control Unit Cover
Battery Charging Alternator
Anti-Drive End Rotor Installation
1. Reposition the alternator in the support stand
with the anti-drive end facing up.
FIGURE 10-133.
2. Install anti-drive end rotor (47) onto shaft
assembly (48). Align the previously-scribed
mark on the face of the rotor with the center of
the screw hole.
FIGURE 10-134.
47. Anti-Drive End Rotor 48. Shaft Assembly
D10-71