Table of Contents
Advertisement
FIGURE 7-74.
34. Lubricate O-ring seal (13) with petroleum jelly or
an oil-soluble grease and install it in the pulley
groove.
FIGURE 7-75.
35. Lubricate hook-type seal rings (17) on the shaft
assembly. Carefully lower the shaft sub-
assembly into the pulley bore and onto the
pulley until the retainer rests on the pulley.
Use caution when lowering. Damage to the
sleeve bearings may result if the shaft is cocked
during installation.
C7-32
36. Install bolts (9) with lockwashers (8). Tighten
each bolt to 49 - 58 N•m (36 - 43 ft lbs).
37. If removed, install orifice fitting (1) in the "oil in"
port of the bracket.
Fan Clutch
FIGURE 7-76.
FIGURE 7-77.
C07001
Advertisement
Chapters
Table of Contents
