Komatsu 830E-AC Shop Manual page 764

13. Use Loctite "LOCQUIC" Primer "T" (TL8753, or
equivalent), to spray mating threads on cap
screws and threads in rod. Allow primer to dry 3
to 5 minutes.
14. Apply Loctite Sealant #277 (VJ6863, or equiva-
lent) to threads of cap screws and threads in
rod.
15. Install plate (2), and cap screws (1). Tighten cap
screws to 780 N·m (575 ft lbs) torque.
NOTE: Allow parts to cure for 2* hours before
exposing threaded areas to oil.
L8-22
* Note: If "LOCQUIC" primer "T" (TL8753) was not
used, the cure time will require 24 hours instead of 2
hours.
16. Install O-ring (12, Figure 8-18) and backup ring
(23) on cover (10). Align and lower cover onto
housing (4). Install cap screws (11) and lock-
washers. Tighten cap screws to standard
torque.
17. Install hoist cylinder eye bearing (5, Figure 8-
17) and retainer rings (4) if removed.
Hoist Circuit Component Repair L08038