Table of Contents
Advertisement
6. Place the shell with the stator in a hydraulic
press. Place stator installation tool XA3322 on
top of the stator. Position the studs in the open-
ings of the tool.
FIGURE 10-99.
Position the shell in a hydraulic press so the
alignment studs are not damaged by the sup-
ports.
7. Press the stator into the shell. The top surface
of drive end stator (56) will be flush with end of
shell (58) when fully installed.
FIGURE 10-100.
56. Drive End Stator
D10003 07/06
58. Shell
Battery Charging Alternator
8. Remove the shell and stator assembly from the
press. Remove the installation tool. Remove the
six alignment studs.
FIGURE 10-101.
NOTE: Precisely align the alignment marks on both
stators and the shell. If they are not aligned, remove
the stator(s) and reinstall.
9. Install nine studs (61) through stators (56 and
59). Install the studs from the anti-drive end of
the alternator with the enlarged portion of the
stud on the anti-drive end.
FIGURE 10-102.
56. Drive End Stators
59. Anti-Drive End
Stators
61. Studs
D10-61
Advertisement
Chapters
Table of Contents
