Komatsu 830E-AC Shop Manual page 288

NOTE: If the drive end stator will not be replaced,
route the phase leads from the replacement anti-
drive end stator through the corresponding spaces
(marked in Step 7a of the Disassembly procedure,
page 55) between the drive end stator windings. New
insulation sleeves and terminals will be installed on
the phase leads during final assembly.
FIGURE 10-89.
3. Align the two scribed marks on the stator with
the scribed marks on shell (58). It is critical that
these scribed marks be carefully aligned. If the
marks are not precisely aligned, the wiring and
the mounting holes will not properly align.
FIGURE 10-90.
D10-58
4. Insert six alignment studs through the holes in
anti-drive end stator (59) aligning them with the
holes in drive end stator (56).
.
56. Drive End Stator
5. Place the shell with the stator into a hydraulic
press. Place stator installation tool XA3322 on
top of the stator.
Battery Charging Alternator
FIGURE 10-91.
59. Anti-Drive End
Stator
FIGURE 10-92.
D10003 07/06