Table of Contents
Advertisement
FIGURE 7-53.
FIGURE 7-54.
14. If removed, install rear dowel pin (2) in shaft
assembly (6). Press the pin until 2.0 mm (0.080
in.) is left exposed above the surface.
If the shaft did not originally come with
pinned bearings, install the dowel per
instructions in Figures 7-53 &7-54.
C07001
15. Use tooling (D) to press rear retainer/seal
assembly (5) onto shaft (6). The inner race of
the retainer should be recessed 1.0 mm (0.040
in.) below the shoulder.
Check carefully to ensure that the retainer/seal
assembly is installed straight and not bent or
damaged in any way which will cause
interference between it and the bearing retainer
after assembly.
Fan Clutch
FIGURE 7-55.
C7-25
Advertisement
Chapters
Table of Contents
