Table of Contents
Advertisement
3. Apply thread lock compound (Loctite) and
install five Torx screws (46) using a T25 Torx bit.
DO NOT install a screw in the scribed hole at
this time. Tighten the five screws to 7 N·m (65
in. lb).
FIGURE 10-135.
46. Screw
4. Ensure the alignment mark has remained cen-
tered with the screw hole. Apply thread lock
compound (Loctite), install the screw. Tighten to
7 N·m (65 in. lb).
FIGURE 10-136.
46. Screw
D10-72
47. Rotor
47. Rotor
Battery Charging Alternator
Anti-Drive End Housing Installation
1. Lubricate the spiral ring with Komatsu grease
XA3401. Wind new spiral ring (50) into the
groove of carrier ring (51).
FIGURE 10-137.
50. Spiral Ring
2. Install two new O-rings (63) in anti-drive end
housing (64).
FIGURE 10-138.
63. O-Rings
51. Carrier Ring
64. Anti-Drive End
Housing
D10003 07/06
Advertisement
Chapters
Table of Contents
