Table of Contents
Advertisement
No Payload Display When Key Switch is Turned ON
• Confirm battery voltage in PLMIII junction box between TB45-A (positive) and TB45-X (ground).
• Check the 5A circuit breaker (CB A) in PLMIII junction box.
• Check all connectors and terminal connectors in the power circuits to the payload meter.
• If two digit display on payload meter displays 00 then 88 on power up, continue to "No Display on Operator
Display". This two digit display normally alternates 0 on each display. In the case of active alarms, this display
will show the code for each active alarm. The alarm codes are in the operation section.
M20-36
Payload Meter III
02/05 M20008
Advertisement
Chapters
Table of Contents
