Adjustment
1. Truck must be parked on a flat, level surface for
inspection.
2. All pads, except the rear pad on each side,
should contact the frame with approximately
equal compression of the rubber.
3. A gap of approximately 1.5 mm (0.06 in.) is
required at each rear pad. This can be accom-
plished by using one less shim at each rear
pad.
1. Dump Body
2. Pad Mounting Hardware
B3-6
Proper body pad to frame contact is required to
assure maximum pad life.
FIGURE 3-4. BODY PAD INSTALLATION
3. Frame
4. Body Pad
Dump Body
4. If pad contact appears to be unequal, repeat the
above procedure.
5. Shim
6. Mounting Pad
B03025