Table of Contents
Advertisement
4. Install nine new lock flange nuts (14) onto studs
(61). Tighten the nuts to 5 N·m (45 in. lb) using
an alternating pattern.
FIGURE 10-122.
14. Lock Flange Nuts
5. Install insulator (13) and then flat washer (12)
on the stator phase lead studs.
FIGURE 10-123.
12. Flat Washer
D10-68
61. Studs
13. Insulator
Battery Charging Alternator
6. Place the stator phase leads onto the stator
phase lead studs and install new hex jam nuts
(11). Tighten the nuts to 3 N·m (30 in. lb).
FIGURE 10-124.
11. Jam Nuts
Position the insulation sleeves on the stator
phase leads over the arm of each terminal ring to
avoid a possible short circuit.
20. Drive End Housing
D10003 07/06
Advertisement
Chapters
Table of Contents
