Operator Controls And Equipment (Figure 3-2); Steering Column And Controls; Dimmer Switch And Turn Signals; Tilt Lever - Komatsu 210M Operation & Maintenance Manual

OM3012.2
Operator Cab and Controls
1. Steering Wheel
2. Turn Signals
and Dimmer Switch
3. Steering Wheel Tilt Lever

(1) Steering Column And Controls

The steering column will tilt up and down and telescope
in and out to provide a comfortable drive position for
the operator, or move up and away for easy entry and
exit.

(2) Dimmer Switch And Turn Signals

The dimmer switch is located in the turn signal lever. If
headlights are on low beam, pulling the lever toward
the steering wheel will change headlights to high beam.
Pulling the lever again changes headlights back to low
beam.
Turn signals lights are activated by moving the lever
"up" to activate right turn lights, and moving the lever
"down" for left turn lights.
OPERATOR CONTROLS AND EQUIPMENT
FIGURE 3-2. OPERATOR CONTROLS
4. Horn/Telescope Adj.
5. Hoist Control
6. Retarder Pedal
Not Shown - HAZARD Flasher Switch below Steering Wheel
7. Service Brake Pedal
8. Throttle Pedal
9. Cigarette Lighter

(3) Tilt Lever

Adjust the tilt of the steering wheel by pulling the Tilt
Lever toward the steering wheel and moving the wheel
to the desired angle. Releasing the lever will lock the
wheel in the desired location.

(4) Horn And Telescoping Adjustment

The horn is activated by depressing the center "button".
Operation of the horn should be verified before starting
engine or moving truck.
The steering wheel adjustment may be moved "in" or
"out" (telescoped) by rotating the housing around the
horn button counterclockwise to unlock the adjust-
ment. After selecting the desired position, rotate the
housing clockwise to lock the adjustment.
Operation - Section 3
Page 3-11
10. Ash Tray
11. Range Selector
12. DO NOT SHIFT Light